Workshop

For anything not listed below please don't hesitate to contact us via the "Customer Support' tab on the top right of the home page. Or alternatively call the workshop direct on 01827 284720 opt 2.

 

Level 1 Check Over £40 - Ideal for new or nearly new bikes!

We charge the same for building and PDI of a new bike (Surcharge for eBikes and DI2).

Main Focus on Gear and Brake Set Up with a general MOT.

  • Chain and Mechs lubricated.
  • Brake cables re adjusted or calipers centralised - Brake pad wear checked - No extra labour for new pads just pay for parts.
  • Bolt torque settings checked over entire bike.
  • Tyre condition checked and inflated.
  • Headset checked and adjusted.

Any further work or advisories will be discussed if needed.

Level 2 Service £79 (Full Suss Bike + £15 for linkage check/grease/torque)

Our most commonly used service package involves a more in depth strip down. Ideal if your bike is overdue a little TLC.

  • Gear clean, lubricate and setup
  • Cables replaced if required
  • Brake clean and setup
  • Headset serviced or bearing replaced
  • Crank removed, bottom bracket serviced or replaced
  • Wheels inspected and trued - any extra work needed is discussed further
  • Frame inspection and clean - frame checked for damage
  • Tyre inspection and pressure check
    • All replacement parts used subject do extra cost - We always price service parts at a competitive rate and will advise before carrying out any replacements.

A must have service if many components are being changed like chain cassette, bottom bracket, headset, wheel bearings or problem solving of issues. We allocate far more time over a Level 1 check as part of a more major service.

 

Level 3 Overhaul £175

You get one of our Cytec approved mechanics for an entire day for a more comprehensive service.

We’ll spend at least 7 hours of the day stripping, cleaning and servicing your bike, treating it like one of our own children. 

Every component is removed, cleaned, lubricated and re installed. All bearings checked cleaned and re greased if possible (new bearings replaced at extra cost). 

Everything you get with a Level 2 service -

  • Gear clean, lubricate and setup
  • Cables replaced if required (at additional cost)
  • Brake clean and setup
  • Headset serviced or bearing replaced
  • Crank removed, bottom bracket serviced or replaced
  • Wheels inspected and trued - any extra work needed is discussed further
  • Frame inspection and clean - frame checked for damage
  • Tyre inspection and pressure check
    • All replacement parts used subject to extra cost - We always price service parts at a competitive rate and will advise before carrying out any replacements.

PLUS

  • If your bike is running Di2 we'l perform a firmware update
  • Additional labour of bearing replacement covered for wheel bearings and full suspension linkage
  • Removal of all components then receive (where applicable) a clean in our parts bath. Re greased and installed.
  • Frame Valet using bike specific 'Finishline' cleaners and polish

All labour for additional upgrades and replacement parts is included in our set fee. 

 

Suspension Service Inc Dropper Posts.

Lower Service on Most Forks, inc genuine oils. New seals carry an additional cost as prices vary due to make and model. £35 + Seals

Reverb Full Service - Using genuine parts £99

Rockshox Rear Shock Servicing From - £95-£110

Fox Rear Shock Servicing From - £95-£110

 

All suspension work is carried out in a dedicated clean area of the workshop using specific genuine tooling, Oils and Parts. During busy times we outsource or seatpost and shock servicing to the relevant manufacturer.

 

Wheel Building and Wheel Related Work

Wheel Build + Spoke - Conventional Wheels £40 Each

Wheel Build + Spoke - Proprietary Spoked Wheels i.e Mavic/Fulcrum/Campag/Carbon £50

Spoke Cost DT DB Silver Nipple 32/36H - £25

Black Nipple + £5

Proprietary Spokes Available - Call For Prices

Wheel True £10-£15 depending on the condition and issue with the wheel.

Replacement Spoke, Tension and True £15 + Cost of spokes.

Hub Service From £15 per wheel

 

Individual Jobs - Can be added to Level 1 and 2 Services if needed.

Gear Tune and Lubricate - As Hanger alignment is a crucial part of a gear tune we include a ‘Mech Hanger Alignment’ within the cost. £20 + Cable costs if needed.

Brake Bleed - Using the correct tools and oils £17.50 per brake + Brake Pad Costs If Needed.

Fitting of new Tube and or Tyres £5 Per Wheel + Cost of new tyre and tube if needed.

Tubeless Conversion £15 per wheel + Cost of any Valves, Sealant, Tape and Tyres.

Labour for none specific work charged at £35 per hour.

Washing of dirty bike charged at £15. We'd much rather not be cleaning your bike we'd much prefer to be working our magic instead. Please bring your bike clean and free of Dog poop (Dog poo will result in a refusal to work on your bike).

Full Custom Builds 

Check out this cool time lapse video we did a while back of an Evil Insurgent build. Just one of many we've done but decided to film this one for the YouTube Masses! Evil Insurgent Custom Build

Please feel free to get in touch with any individual issues or needs.

Please accept cookies to help us improve this website Is this OK? Yes No More on cookies »